Pricing

    - Prepare boat for season test and fill batteries

    - Clean connections

    - Check and top off fluids

    - Check all accesories (I.E. blower, bilge, pump, etc.)

    - Sea trial

    - Test engine performance

    - Change fuel water separator

    - Includes commission

    - Remove and replace spark plugs

    - Cap and rotor

    - Fuel filter

    - Cylinder compression test

    - Check engine timing

    - Adjust to factory specs

    - Sea trial

    - Including replacing spark plugs

    - Cap

    - Rotor

    - Fuel filter

    - Sea trial

    - Addition to tune up, replace spark plug wires

    - Including replacing spark plugs

    - Fuel filter

    - Sea trial

    - Hook engine to water source

    - Run to temp

    - Remove and replace oil, filter and dispose

    - Test

    * Diesel is an additional charge

    - Remove outdrive

    - Check engine alignment

    - Grease U-joint

    - Check gimbal bearing

    - Change gear oil

    - Clean gear oil reservoir

    - Grease prop and all fittings

    - Replace drain screw gaskets

    - Replace mounting gaskets

    - Hook engine to water source

    - Run to temp

    - Remove and replace oil, filter and dispose

    - Test

    * Diesel is an additional charge

    Drain and fill

    Replace drain screw gaskets

    - Replace all necessary components to include U-joint

    - Exhaust and shift cables bellows

    - Water intake hose

    - Shift shaft seals

    - Shift cable

    - Gimble bearing

    - Trim senders

    - Set/adjust as needed

    - Drain and replace fluid and filter as needed

    - Test proper operation

    - Drain gear oil

    - Remove outdrive

    - Separate lower

    - Remove and replace impeller parts as needed

    - Replace gaskets

    - Reinstall lower

    - Check engine alignment

    - Grease U-joint

    - Check gimbal bearing

    - Change gear oil

    - Clean gear oil reservoir

    - Grease prop and all fittings

    - Replace drain screw and mounting gaskets

    - Reinstall outdrive

    - Test for proper operation

    - Remove and replace impeller and components as needed

    - Test

    - Remove lower

    - Drain and replace gear oil

    - Replace necessary impeller parts and components as needed

    - Test

    - Run to temp

    - Remove and replace oil and filter with factory recommended/disposal

    * Diesel is an additional charge

    - To include (if applicable) fresh water system

    - Head

    - AC

    - Deck wash

    - Hot water heater

    * $30 Evironmental fee will be added

    * Estimated 30% of parts deposit (not on storage).

    * Any remaining materials and additional labor will be added to the final bill.

    * 4% shipping add to all work orders.

    * Invoices will be sent for deposits if applicable.

    * Any Payment not paid 30 days of issuance of final bill will be charge an additional 10% on total bill due as a late fee charge per month there after.

    * Any vessel not picked up with in 5 days of the service being completed will be charged storage fee of $10 per day.

    * Total amount of the bill due within 15 days of the invoice date.

    * By signing this form, you authorize Nauti-Sea Solutions to perform selected services.

    NO BOATS WILL BE LAUNCHED UNLESS ALL INVOICES ARE PAID IN FULL

    1. Winter Land Storage is for the period of Oct 15 to April 15. Storage beyond April 15th will be billed separately at the rate of $10/per day unless prior agreement made.

    2. Parking in the Fall and Spring is limited due to Land Storage. Please be considerate of where you park, boats are being moved for either storage or launching. Please avoid blocking other vehicles.

    3. Nauti-Sea Solutions or Selby Bay Marina will not be held responsible for theft, fire, vandalism, acts of God or any other means beyond our control. Insurance must be maintained on vessels at all times.

    4. Winterization, WinterLand Storage and Shrink Wrapping are scheduled on a first-come, first serve basis. Marina is not responsible for any freeze damage to vessels due to late winterization request.

    5. If you have a preferred launch date please note the date on the contract.

     

    PROHIBITED

    1. Boats must be pressure washed in the designated area only. No Exceptions. This is a NEW LAW and failure to comply could result in a fine, legal fees and clean up cost being passed to you.

    2. Moving jack stands or blocks, attaching anything to blocking materials or stands while boat is in Land Storage is dangerous and may result in damage to your boat and neighboring boats.

    3. Disposal of Shrink Wrap in a Marina trash dumpster.

    4. Using anything other than non-toxic marine anti-freeze.

    5. No oils, gas, holding tanks, paints, thinners, or anti-freeze may be poured or drained on grounds, in water, in bathrooms or in sewer storm drains. If found violating this regulation, you will be responsible for all fines, legal fees and clean up cost.

    6. Trash or debris being left around boats or in the yard.

    7. All sanding and painting without vacuum dustless sanders and ground protection is prohibited (see #5 under Permitted).

    8. Sand blasting or spray painting, unless authorized.

    9. Unauthorized use of any electricity.

    10. Use of heaters of any kind, while boat is in Land Storage. Heaters cause fires and endanger all vessels stored on-land.

     

    PERMITTED

    1. Canvas, boat covers and shrink wrap are permitted on land. If these or any other type of covers are used and cause damage to your vessel or nearby vessels, it will be your and your insurance company’s responsibility. The Marina recommends using Shrink Wrap covering. Shrink Wrap blocks out wind and winter elements and provides better protection for the boat.

    2. Owners may work on their boats while in Land Storage. Please contact the Marina when you are working so we are aware in case of emergency.

    3. Land Storage customers may dispose of oil in our waste oil drum for a fee. See the Service Department for location.

    4. No outside tradesmen are permitted to work on boats stored at the Marina without prior permission of the SBM. If allowed they must contact the Marina to obtain and complete the required documents before performing work on any vessel. If the Owner or Tradesman does not follow this procedure, no work will be performed.

    5. All sanding/painting MUST be performed with vacuum dustless sanders and ground protection to catch all te particles and chemicals that are used. They may not be disposed of on grounds or in water.